Instructions:
1.

Remove the metal clamp from the folder by drilling open the studs. Place drill holes according to the measurements (download) in the corner of the multiplex board. Push the screws through the back and glue.

2.
Glue the material for the pillow cover 4 cm from the left and the right rim on the back of the wooden board. Cut two layers of polyester batting 300g/sqm and push it underneath the pillow cover. Wrap the still open sides of the cover around the wooden board and glue them as well.

3.
Cut the rods into lengths of 85 cm and stick the ends up to the middle into the cm long plastic pipes. Stick in and glue the 5 cm long pieces of steel rope into the other end of the pipes and glue. Push the rods with their ends crossed over into the screws and also fix them into place with the glue.

4.
Cut the semi-transparent material according to the pattern (download) and sew as indicated.

5.
Place the material across the rods, wrap the untrimmed edges around the upholstered wooden board and glue from the back. Now glue the finished tent into the center of the open file folder.

6.
Stick the Velcro tape onto the file folder as a latch. Download the label and the chill-out sounds here and off you go! It's naptime!


Ingredients:

1 file folder (broad back)
2 pcs. of 3 mm polystyrene or fiberglass rods, 85 cm
4 pcs. of 3 mm steel rope, 5 cm
4 pcs. 5 mm small plastic tubes, 5 cm
4 screws M5/2 cm
2 pcs. Multiplex wooden board 4 mm, 31 x 27 cm
1 multiplex wooden board 4 mm, 31 x 6 cm
2 x polyester batting 300g/m, 29 x 55 cm
1 semi-transparent silky material, 106 x 80 cm
1 pillow cover, 40 x 65 cm
1 pc. of Velcro tape, 40 x 65 cm
1 pc. of Velcro tape, 15 cm
1 tube of epoxy glue